270-Point Breadboard

This 3.25" x 1.75" breadboard has two bus lines spanning the length of the board and 23 rows of pins, enough for up to three 14-pin DIP ICs, or two 16-pin DIP ICs. The rows and columns of tie points are conveniently labeled. There are four mounting holes, and tabs for connecting multiple units for larger projects.

Breadboards are commonly used for prototyping because they allow you to quickly build temporary circuits without soldering. Breadboards accept most through-hole parts and up to #22 wire. When you’re done or want to change your circuit, it’s easy to take your circuit apart. For best results, use solid wires when breadboarding.

You’ll find these pre-cut jumper wire kits especially convenient.