I-Stamp2P Project Kit, Includes i-Stamp2P module and JX-2P Plus board with component set for experiment activities

i-Stamp2P Microcontroller board

* Features are compatible with the BASIC Stamp2P 40 module (BS2P40-IC)
* 20MHz Clock frequency. Up to 12000 P-BASIC commands/second
* 16K of memory
* 32 Bytes of RAM with 64 Bytes of scratchpad RAM
* 65mA in full operation and 200uA in sleep mode
* Serial communication with PC for programming and debugging
* 32 I/O individually or in groups of 4, 8 or 16 pins
* Develop applications with the BASIC Stamp editor program

JX-2P Plus Project Board

* Socket for i-Stamp2P (OEM BASIC STamp2P included)
* RJ-11 female connector for downloading and communicating
* +5V Power supply on board
* 24 free i-Stamp2P ports available (P0 to P15 and A0 to A7)
* 3 RC Servo motor ports available (P13 to P15)
* LCD module interface with brightness adjustment
* DS18B20 1-wire temperature sensor IC on board
* Large prototyping area available
* Separate power supply terminals available for servo motors
* On board power supply polarity protection

Included in the kit:
* JX-2P Plus project board
* i-Stamp2P OEM board
* 400 Point breadboard with #22 AWG hook-up wire
* DC Mains adaptor
* LCD16x2 with cable
* CX-4 Serial port cable
* Experiment component set includes all parts for experiment actives
* Documentation and software on CD-ROM

What does the documentation show you?
* Introduction to i-Stamp2P microcontroller
* i-Stamp2P and JX-2P Schematic diagram and board layout
* Getting started step by step
* Example programs:
- Running lights using LED's
- 4-Digit counter using 7-Segment display
- Playing a note, generating sine waves
- Measure the charge or discharge time of a resistor or capacitor
- Using the LCD 16 character display
* I2C Bus experiments
- Using the PCF8574A I/O expander
- Reading time from the Maxim DS1307 real-time clock
- Reading temperature from the Maxim DS1621 digital thermometer
* Other experiments
- Using the on-board 1-wire DS18B20 digital thermometer
- Driving a dc motor using the L272M dual power op-amp