Metal Gearmotor Details (37Dx57L mm)

Gearmotor Dimensions:

The face plate has six mounting holes evenly spaced around the outer edge threaded for M3 screws. These mounting holes form a regular hexagon and the centers of neighboring holes are 15.5 mm apart. You can use our custom-designed 37D metal gearmotor bracket (pictured below) to mount the gearmotor to your project via these mounting holes and the screws that come with the bracket.

	Gearmotor with bracket and hub.

Please note that unlike our smaller metal gearmotors, these 37D mm gearmotors have output shafts with a diameter of 6 mm. The hub in the picture above can be used to mount custom wheels and mechanisms to the gearmotor’s output shaft.

The picture below shows the dimensions (in mm) of the 37D mm line of gearmotors. The value of X is 22 mm for the 19:1 37Dx52L mm and 29:1 37Dx52L mm versions, 24 mm for the 50:1 37Dx54L mm and 67:1 37Dx54L mm versions, and 26.5 mm for the 100:1 37Dx57L mm and 122:1 37Dx57L mm versions.

	37D mm metal gearmotor dimensions (units in mm).

Warning: Do not screw too far into the mounting holes as the screws can hit the gears. We recommend screwing no further than 3mm (1/8") into the screw hole.

These motors are intended for use at 12 V, though the operational specs listed in the table below were measured at 6 V. At 12 V, the no-load RPM, stall current, and stall torque will all be approximately twice their 6V values. To see the motor specs for 12V operation, please see the short description at the top of this page.

These motors are intended for use at 12 V, though the operational specs listed in the table below were measured at 6 V. At 12 V, the no-load RPM, stall current, and stall torque will all be approximately twice their 6V values. To see the motor specs for 12V operation, please see the short description at the top of this page.

	19:1 metal gearmotor 37Dx52L mm next to a micro metal gearmotor for size comparison.

Please look at the gearmotor comparison chart.